This is an excerpt from Weight Training-4th Edition by Thomas R. Baechle & Roger W. Earle.
Back Drill 2.
Warm-Up and Trial Loads for Basic Exercises
This practice procedure answers the question “How much weight or load should I use?” Using the coefficient associated with the back exercise you selected and the formula shown in figure 5.5, determine the trial load. Round your results down to the nearest 5-pound (2.3 kg) increment or to the closest weight-stack plate. Be sure to use the coefficient assigned to the exercise you selected. Use half of the amount determined for the trial load for your warm-up load in the exercise. These loads will be used in drills 4 and 5.
- Determine your trial load by multiplying your body weight by the correct coefficient.
- Determine your warm-up load by dividing your trial load by two.
- Round down your trial and warm-up loads to the nearest 5-pound (2.3 kg) increment or to the closest weight-stack plate.
Back Drill 3.
Determine Trial Load for *Lat Pulldown
If you are an experienced lifter who decided to add the *lat pulldown, follow the directions to determine the trial load.
Based on your previous experience and knowledge of the weight that you can lift, select a weight that will allow you to perform 12 to 15 repetitions. Calculate the warm-up load by multiplying the trial load by 0.6 and round down to the closest weight-stack plate (figure 5.6). These loads will be used in drill 4.
- Select a weight that will allow 12 to 15 repetitions.
- Determine the warm-up load by multiplying the trial load by 0.6.
- Round down the warm-up load to the closest weight-stack plate.
Back Drill 4. Practice Proper Technique
In this procedure, you are to perform 15 repetitions with the warm-up load determined in drill 2 (bent-over row, machine row, or seated row) or drill 3 (*lat pulldown). If you are an experienced lifter who decided to add the *lat pulldown, practice it last.
Review the photos and instructions for the exercise, focusing on proper grip and body positioning. Visualize the movement pattern through the full range of motion. Perform the movement with a slow, controlled velocity, remembering to exhale through the sticking point. Ask a qualified professional to observe and assess your technique.
- Check movement pattern.
- Check velocity.
- Check breathing.
Back Drill 5. Determine Training Load
This practice procedure will help you determine an appropriate training load designed to produce 12 to 15 repetitions. For basic exercises, perform as many repetitions as possible with the calculated trial load from drill 2. Make sure that you perform the repetitions correctly. If you are doing the free-weight bent-over row, also check that your hips are lower than your back and that the bar touches at or near the nipples.
If you performed 12 to 15 repetitions with the trial load, then your trial load is your training load. Record this weight as your training load for this exercise in the workout chart. If you did not perform 12 to 15 repetitions, go to drill 6 to make adjustments to the load.
- Check that you are using the correct load.
- Maintain proper and safe technique during each repetition.
Back Drill 6. Make Needed Load Adjustments
If you performed fewer than 12 repetitions with your trial load, the load is too heavy, and you need to lighten it. On the other hand, if you performed more than 15 repetitions, the trial load is too light, and you need to increase it. Use figure 5.7 to determine the adjustment you need to make and the formula for making load adjustments.
- Check correct use of load adjustment chart (figure 5.7).
- Write in your training load on the workout chart.
Read more from Weight Training: Steps to Success, Fourth Edition by Thomas R. Baechle, Roger W. Earle.More Excerpts From Weight Training 4th Edition
Get the latest insights with regular newsletters, plus periodic product information and special insider offers.